When I've used it on a mac, it works perfectly. I rarely use the UMC device, and have only plugged it in a few times over the past few days repeating the steps I described above. Setup for mic: Mic-XLR to Input 1/2, Pad pressed/depressed, Phantom power on, Gain between 50-100%ĭrivers have been installed from Behringer's website. Setup for instrument: Bass-1/4" cable to Input 1/2, INST pressed in, tried both pressed in/out for Pad, Gain between 50-100% (I've tried using my guitars, as well as multiple cables too) I can confirm that the PC sees the device(s). I was wondering if signal was still passing, and attempted to record in my DAW (Studio One), but no signal was recorded. I also have a Behringer UMC404HD, and that is producing the same results. I also connected the hardware to a powered USB port, but still no luck. I've also tried plugging into channel 2 with the same result hooking up a condenser mic on both channels with no apparent signal either. However, I'm not getting any indication of input signal on the UMC device (no green light on 'SIG'). I'm attempting to use a bass plugged directly through my Behringer UMC204HD into my laptop (W10 PC).
0 Comments
Leave a Reply. |